First off I would like to thank you and your crew for your generosity
and commitment towards the diy community.

Thanks to your efforts, and a little help from the guys over at
diyaudio.com I have successfully built my very own Aleph 3 clone.

The chassis is made of 3mm aluminum plates except for the front panel witch is 6mm. The sinks are rated at 0.3 C/W and the temperature stabilizes at a little over 55 degrees Celsius.

The power supply consists of 2x18V 600VA toroid, and 22 x 4700uF
capacitors. Rail voltage under load is +/-23.5V. DC offset is less than
30mV. 

As far as the sound goes, it is everything I hoped for and then some.

Best regards,

Sven Sødem